MIL-S-45669A(MU)
4.4.3 Failure of sample.- Should any one item of a special sampl-
ing fail to meet the specified test requirements, acceptance of the re-
presented inspection lot will be suspended by the Government until ne-
cessary corrections have been made by the contractor and the resubmitted
samples have been approved (see 4.3.3).
4.5 Inspection equipment.- Except as otherwise provided for by
the contract, the contractor shall supply equipment in accordance with
the applicable requirements of MIL-I-45607.
4.5.1 Government furnished inspection equipment.- Where the con-
tract provides for Government furnished test equipment, care and maint-
enance of test equipment shall be in accordance with the applicable re-
quirements specified in MIL-I-45607.
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design.- Unless otherwise specified in the con-
tract, all inspection equipment specified by drawing number in specifica-
tions or SQAP forming a part of the contract shall be supplied by the
contractor in accordance with technical data listed in the List of Inspec-
tion Documents when provided with the technical data package (TDP).
4.5.2.2 Contractor design.- The contractor shall design and supply
inspection equipment compatible with the "Test Methods and Procedures"
specified in 4.6 of this specification and with the component inspection
procedures specified in "Examination" and "Test facilities" requirements
of MIL-F-13926. Since tolerance of test equipment is normally considered
to be within 10% of the product tolerance for which it is intended, this
inherent error in the test equipment design must be considered as part
of the prescribed product tolerance limit. Thus, concept, construction,
materials, dimensions and tolerances used in the design of test equipment
shall be so selected and controlled as to insure that the test equipment
will reliably indicate acceptability of a product which does not exceed
90% of the prescribed tolerance limit, and permit positive rejection when
non-conforming. Construction shall be such as to facilitate routine
calibration of test equipment.
4.6 Test methods and procedures.
4.6.1 Vibration.- The bore sight shall be vibrated by means of a
device capable of meeting the requirements of 3.5. With the aid of a
suitable adapter, the Bore Sight, M45 shall be secured firmly to the de-
vice and vibrated in the position (a) indicated on Figure 1.
4.6.2 Orientation.- orientation is accomplished by means of a
special testing device to assure correct orientation in the three posi-
tions indicated on Figure 1. The device shall consist of a simulated
tube, with a base capable of supporting the tube, at an angle of 45 de-
grees plus or minus 20 seconds. The outside diameter of the tube shall
-7-
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business